A well detailed engine, is sharp, crisp, neat and as tidy as the exterior of the car. Engine bay detailing fascinates mechanics who treat your ride differently when they notice the engine bay is spotless. Itsends a signal to them that you take your car care seriously. Aside this, regular detailing of engine bay also increases your ride’s resale value.
Cleaning the engine bay is, however, not a cumbersome engagement. You only need a level of engine warmth (not hot) to properly detail your engine. This will quicken the shift of more concentrated dirt build up. Simply warming and turning on of engine for a minute or two and then turning it offis enough. You should followthe below guide to properly detail your car engine bay.
Step 1: Remove Excess Dirt and Cover up Vital Parts
The first detailing step for car engine bay is to eliminate excessive debris and dust trapped within the grille, hood and vent openings. Compressed air is ideal for removing old leavesand debris. However, hand brushing of the area too will suffice.
You should afterward, cover water susceptible areas of the engine. Using a plastic bag and a tape to hold, mask up all electronics, including the air intakes, spark plug openings,coil packs, electronic control unit, alternator and On-Board Diagnostics.
Step 2: Spray with non-Petrol-Based Cleaner.
The second detailing activity is spraying your engine bay with citrus- or water-based cleaners. Note that petrol-based cleaners quicken deteriorateof vinyl and rubber parts; aside the environmental dangers it poses. However, non-petrol-based degreasers may be used, spraying the engine degreaser unto areas with build-up of grimeanddirt. You should start from top to bottom in order to avoid the degreaser dripping over you.
After application, leave it for 4-5 minutes.You may then agitate certain areas with your detailing brush, if you consider it necessary to cut through the grease.Ensure the application does not dry out on your engine surface.
STEP 3:Hose Off Engine Bay
After you have thoroughly cleaned and loosened all embedded dirt and grime from the entire engine bay, remove the degreaser by hosing down the whole area using a jet wash or hose. Be mindful of the electronic connection areas earlier masked up with plastic bags,
STEP 4:Wipe Down the Engine Bay
After hosing your engine bay compartment, let it air out for a couple of minutes then using a microfibre towel, wipe down the entire accessible areas and ensure the engine driesoff evenly.The engine heat will likewise assist you to dry up the parts. You may then take out the tapes and plastic bags from the electronic parts once you are satisfied that the whole compartment is fully dried.
.
STEP 5: Apply Engine Protectant Coat
You should complete engine bay detailing by applying coating of engine protectant or rubber and vinyl protectant. This not only add shine but protect your engine bay areasfrom quick wears, rust and corrosion. Endeavour to use a high-quality detailing spray, applying it on the whole surfaces. Finally, use a clean towel to wipe off excessive spray.